Operating Determinations - EuroLite STC Bedienungsanleitung

When using stands under the influence of horizontal forces, e. g. through wind, the standing safety can be
impaired. This is why additional safety measures like attaching ballast weights have to be taken.
If inclined tension cables or prolonged outriggers are used, the area of danger has to be marked or even be
blocked.
Before lifting or lowering the telescopic tubes, you must always block a safety area around the stand. This
safety area must have a diameter of 1.5 times the maximum height.
Lifted telescopic tubes always have to be secured with a secondary securing!
All devices, lighting effects and crossbeams attached on a stand must be secured with a secondary
attachment!
Before taking into operation, every stand has to be checked upon possible damages.
If one part of a stand is defective, the stand must not be taken into operation.
You read, understand and obey the manufacturer's instructions and safety rules, the user manual and
machine stickers.
You read, understand and obey employer's safety rules and worksite regulations.
You read, understand and obey all applicable governmental regulations.
You are properly trained to safely operate the machine.
Keep away children and amateurs!

OPERATING DETERMINATIONS

This truss lifter is a machine – in the sense of the EU's machine guideline – for lifting and lowering loads in
vertical direction.
The given carrying capacity of the stand must not be exceeded.
This stand is designed for professional use, e.g. on stages, in discotheques, theatres etc.
Stands with their loads have to be secured against unintended movements.
When choosing the installation-spot, please make sure that the stand has to be installed in a way that no
person can enter the area below the stand or its load! Make sure that the respective area is blocked.
An unintended movement of the load has to be avoided - also in case of fire!
Stands have to be operated by instructed persons. The different local conditions have to be considered in
terms of safety rules.
The installer is responsible for adhering to the carrying capacity given by the manufacturer, the safety
requirements and the qualification of possible co-workers.
When people are located below the load, all necessary safety measures have to be taken in order to avoid
injury.
The personnel has to be instructed on the content of the user manual and on the dangers related with
operating stands.
Depending upon the individual installation spot, all necessary measures against movement and for securing
the standing safety have to be created.
18/26 00037766.DOC, Version 1.0