EuroLite STC Bedienungsanleitung Seite 20

Prior to use, check the work area for drop-offs, holes, bumps, debris, unstable or slippery surfaces or other
possible hazardous conditions.
Danger to life due to high voltage
This machine is not electrically insulated and will not provide protection from contact with or proximity to
electrical current.
Keep away from the machine if it contacts energized power lines.
Personnel must not touch or operate the machine until power lines are shut off.
Maintain safe distances away from electrical power lines and apparatus in accordance with applicable
governmental regulations and the following chart:
Voltage
Phase to Phase
0 to 300 V
300 V to 50 kV
50 kV to 200 kV
200 kV to 350 kV
350 kV to 500 kV
500 kV to 750 kV
750 kV to 1000 kV
Allow for mast movement and electrical line sway or sag, and be aware of strong or gusty winds.
Do not use the machine as a ground for welding.
Crushing hazards
Do not release the winch handle until the brake is locked. The brake is locked when the load will not cause
the winch handle to turn.
Do not raise unless the load center (balance point) is properly positioned.
Do not stand under or allow personnel under the machine when the load is raised.
Do not stand under the load. The safety brake system will allow the load to drop uncontrolled before locking
the columns.
Do not raise unless the load is properly secured.
Do not lower the load unless the area below is clear of personnel and obstructions.
Keep hands and fingers away from any potential pinch points.
Collision hazards
Do not tilt the machine back unless the area is clear of personnel and obstructions.
Check the work area for overhead obstructions or other possible hazards.
Use common sense and planning when transporting the machine on an incline or slope.
Do not load for transport unless the machine and vehicle are on a level surface. Use proper lifting techniques
to load the machine.
Damaged machine hazards
Do not use a damaged or malfunctioning machine.
Do not use a machine with a worn, frayed, kinked or damaged cable.
Do not use a machine with less than 4 wraps of cable on the winch drum in the stowed position.
Conduct a thorough pre-operation inspection prior to each use.
Be sure that the operator's manual is complete, legible and with the machine.
Be sure all stickers are in place and legible.
Maintain proper lubrication on the winch. Do not allow oil or grease on braking surfaces.
Do not use any type of lubrication on the column surfaces.
Bodily injury hazard
Do not grasp the cable.
Lifting hazards
Use proper lifting techniques to load or tilt the machine.
Minimum Safe
Approach Distance
Feet Meters
Avoid Contact
10 3.1
15 4.6
20 6.1
25 7.6
35 10.7
45 13.7
20/26 00037766.DOC, Version 1.0