Technical Data Charger And Battery (C); Function Of The Unit; Overview (A); Working Notes - Rothenberger Rocam 4 Plus Bedienungsanleitung

Slide cable diameter ....................... ø 7.0 mm / ø 8.0 mm (optional ø 5,5 mm Mini Modul)
Working range ................................ Ø 40 - 100 mm (optional Mini Modul)
Positioning transmitter .................... 33 kHz (bolt-on optional)
Protection class camera head ......... IP 68
Included in delivery: ROCAM 4 Plus TV- inspection system with Camera head ø30 mm or ø40
mm, guide ball, positioning transmitter 33 kHz, USB cable, test adaptor, manual, 4 GB SD card,
battery and charger.
3 Technical Data charger and battery
Battery:
U = Voltage
C = Capacity
W = Weight
Ic = Charge current
t
= Approx. charging time (90% full)
Charging voltage.............................
Charging temperature .. 0° - 50° C, 32° - 122° F
Max. discharging
temperature. ................................
Recharge battery pack before first use!
4

Function of the Unit

4.1 Overview
Camera head
1
Positioning probe
2
Bending spring
3
Reel cable
4
Rear flap
5
Front flap
6
4.2

Working notes

- Do not bend the reel cable! The cable may break!
- Do not pull the reel cable over sharp edges! The cable may become damaged!
ATTENTION! Always protect ROCAM 4 Plus against water, and use only recom-
mended indoors. Only the camera head (1) and reel cable (4) may come into contact
with water!
4.3

Changing the battery

 Open the rear cover (5).
 Insert the battery into the compartment on the right side of the accessory compartment until
it clicks. To remove, press the locks and pull the battery out.
4.4

Working with the device

Wear protective clothing! Always stand next to the reel cable!
 Push reel cable (4) with bending spring (3) from the holder (10) / reel (8) take and remove
cap.
 Remove the cap from the camera head (1) and screw on the bending spring (3).
Ø 70 - 150 mm (30 mm camera head)
Ø 100 - 300 mm (40 mm camera head)
20,75 V DC
5° - 50° C, 41° - 122° F
ENGLISH
Charger:
U1 = Input voltage
f1 = Input frequency
P1 = Input power
U2 = Charging voltage
= Max. charge current
I2
Nc = No. of battery cells
W = Weight
Pay attention to the electrical outlet
voltage! Check the label on the
bottom of the charger!
Monitor unit
7
Reel
8
Frame
9
Holder / Bracket
10
Guide hook
11
ROCAM 4 Plus - AC - adapter
12
(C)
(A)
25