How To Use - Lionelo Braam Bedienungsanleitung

K. Seat liner
L. Support leg indicator
M. Base 360 ° rotation button
N. Base
O. Seat tilting handle
P. Hip belt guide
Q. Headrest
R. Headrest height adjustment lever

How to use

HOW TO FASTEN BELTS OF THE CHILD SAFETY SEAT
To fasten belts of the child safety seat (fig. 5):
1. Join belt buckles.
2. Insert them in the buckle (G), you will hear a distinctive „click".
3. Make sure the belts have been properly tightened and are not twisted.
To unfasten 5-point belts of the child safety seat, press the red button (F) on the buckle
and loosen the belts.
HOW TO ADJUST TENSION OF THE CHILD SAFETY SEAT BELTS
1. To tighten the belts, pull the tension adjustment strap (J) (fig. 6).
2. To loosen the belts, press adjustment button (I) and pull the shoulder belts (D) (fig. 7).
Note! Make sure the child safety seat belts fit tight the child's body and are not twisted.
Make sure the hip belts go low and protect the child's pelvis. The belts must fit tight the
child's body but must not be too tight and cause discomfort.
HOW TO DISASSEMBLE CHILD SAFETY SEAT BELTS
• Open the manual locker.
• Pull the metal belt connector (T) out of the plastic fastener, and then remove the belts
(fig. 8).
• Loosen the belts as much as you can (see chapter: HOW TO ADJUST TENSION OF
THE CHILD SAFETY SEAT BELTS).
• The metal belt connector must be placed in a special spot for future use (see: fig. 9).
• Unfasten Velcros on belt protective cushions.
• Unfasten child safety seat covering Velcros. Pull the buckle through the hole in the
covering.
• Fasten belts and hide them in the glovebox in the child safety seat.
Installation of belts must be performed in a reversed order.
S. Shoulder belt guides
T. Top belt connector
U. Manual locker
V. ISOFIX arms
W. Support leg
X. ISOFIX button
Y. Support leg adjustment button
Z. ISOFIX sheaths
‑ 11 ‑ EN