Control Via The Unicon Remote Unit - Cameo H1 D Bedienungsanleitung

Loosen the 2 securing screws of the terminal block with the power supply cables and remove
it from the corresponding terminal (terminal block connector D). Use suitable ferrules for the
stripped cable ends and attach the 3-core mains cable to the corresponding contacts of the
accompanying terminal block for the power supply. Observe the correct allocation (see diagram
below, L=Live, G=Ground/Earth, N=Neutral). Attach the terminal block to the corresponding termi-
nal block connector (D) and secure it with screws.
Remove the terminal blocks for DMX IN (E / DMX1) and DMX OUT (F / DMX2) from the terminal
block connector and connect the 3 leads from the DMX cable to the corresponding contacts on
the terminal blocks (G = Ground/Earth, - = Negative, + = Positive). Attach the terminal blocks to
the corresponding terminal block connectors, then seal the connection terminal with the terminal
cover and secure it with the previously loosened screws. Protect the terminal connector from me-
chanical stress by ensuring that the clamping nuts for the cable bushings are securely tightened.

CONTROL VIA THE UNICON REMOTE UNIT

Operation of the spotlight models H1 D and H1 T is identical. For simplicity, the model designation
H1 D is used in the following text and in the illustrations.
16
DMX1
L G N
G - +
D
E
DMX2
G - +
F
FUNCTIONS OF THE OPERATING
ELEMENTS
Display
Value up

Value

down
Back

Confirm

Encoder +
BACK


BACK
Encoder