Dip Switch Function - Cameo H1 D Bedienungsanleitung

4
DIP SWITCH
Eight DIP switches for basic configuration of the spotlight. To fully configure the spotlight, you
need the optionally available UNICON remote unit.
DIP switch Function
1 ON Selection of RJ45 wire pair
2 ON
3 ON
4 ON
5 Service
6 ON Activate W-DMX
7 ON Status LED deactivated
8 ON Full On
5
ANTENNA
Antenna for wireless control via W-DMX.
6
W-DMX RESET BUTTON
Button for disconnecting W-DMX connections and for pairing the spotlight with W-DMX devices.
Activate the W-DMX receiver of the spotlight (DIP switch 6 in ON position) and reset the receiver
by pressing the button for approx. 3 seconds. All previous connections are disconnected and the
receiver is set to pairing readiness for approx. 1 minute; the status LED no. 7 flashes red quickly.
The receiver is now waiting for a transmitter pairing request. Start the pairing process on the
transmitter; the pairing occurs automatically.
In the same way, several receivers can be paired to a transmitter either simultaneously or one
after the other. A W-DMX connection is always maintained until the connection is disconnected by
means of the Reset command in the receiver or the Unlink command in the transmitter, regardless
of whether a device has been disconnected from the power supply in the meantime.
Explanation
The incoming DMX signal can be routed to one
of the 4 available wire pairs
Switch OFF -> ON -> OFF (within 2s) = factory
reset
Switch 8 ON has priority over all other settings
13