Infrared Remote Control - Cameo LED MINI PAR CAN Bedienungsanleitung

OPERATION:

INFRARED REMOTE CONTROL

BL (BLACKOUT): If you press this button when the light is on, all of the
LEDs are blacked out. If the BL button is pressed again, the light returns to
the previously selected operating mode.
Brightness cold white (CW): The brightness of the cold white LEDs can
be adjusted in three levels using the three buttons 50%, 75%, and 100% in
the top row of buttons.
Fine adjustment is then carried out by pressing the + and - buttons.
Brightness warm white (WW): The brightness of the warm white LEDs
can be adjusted in four levels using the four buttons 25%, 50%, 75%, and
100% in the second row of buttons.
Fine adjustment is then carried out by pressing the + and - buttons.
D (DMx MODE): When this button is pressed, the LEDs of the light go out.
Now it can be controlled by a DMX controller.
FL (FLASH): Pressing this button starts the stroboscope effect at a mode-
rate speed. The flash speed is increased using the + button and decreased
using the - button.
SL (SLAVE): Pressing this button sets the light to slave mode. Connect the
slave and master unit of the same type with a DMX cable (master unit DMX
OUT - slave unit DMX IN). Now the slave unit follows the master unit.
S (SET ADDR): To set the light to the DMX start address (001 - 512) via
the IR remote control, first press the S button (the cold white LEDs light up),
then the first digit (0 - 9 buttons of the IR remote control) of the desired
DMX start address (the warm white LEDs light up), now the second digit
(the cold white LEDs light up), and then the third digit of the desired DMX
start address (the input is confirmed by triple flashing of all LEDs). Now the
light can be operated via DMX with the start address that has just been set.
10
BLACKOUT CW
50% 75% 100%
WW
25% 50% 75% 100%
DMX MODE FLASH SLAVE SET ADDR
D FL SL
1 2 3
4 5 6
7 8 9
S
0