Storage; Disposal And Recycling; Troubleshooting - Scheppach PM1400 Original Bedienungsanleitung

of any enquiries:
• Type of current for the motor
• Machine data ­ type plate
• Motor data ­ type plate

11. Storage

• The whole machine and all accessories must be
thoroughly cleaned.
• Store the machine always out of children's reach.
Put it in a secure position in a dry and safe place
where no extremely high or extremely low tem-
peratures may occur.
• Protect the stored machine from direct sunlight;
put it in a darkened area, if feasible.
• Do not wrap the machine into bags or covers made
of nylon or plastic, as dampness may develop.

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with house-

13. Troubleshooting

Problem
Motor does not start.
Unusual vibrations
Device starts but blocks under
slight load and cuts off auto-
matically.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
No power supply (power failure)
Mains cable defective.
Motor or switch defect
Beater defective.
Chuck defective.
Non-intended material to be mixed.
Extension cable too long, or crosssection
too small.
Socket too far away from main connec-
tion, and cross-section of connection
lead too small.
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequenc-
es for the environment and human health due to po-
tentially hazardous substances that are often con-
tained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Remedy
Check fuses
Exchange defect cable, respectively
check extension cable, (by electrician)
Never use defect lead
To correct the problem, refer to the
manufacturer or other approved service
centre.
Replace the beater.
To correct the problem, refer to the
manufacturer or other approved service
centre.
Incorrect processing. Follow the process-
ing instructions from the supplier.
Extension cable at least 1,5 mm
mum 25 m long.
Cross- section of at least 2,5 mm
longer cables.
, maxi-
2
in
2
GB | 21