Cleaning Methods; Care And Service - Kärcher Puzzi 10/1 Bedienungsanleitung

Flushing the device
1. Connect the angle piece (with suction pipe and floor
nozzle) to the suction hose.
2. Connect the spray hose coupling to the angle piece
and latch into place.
3. Pour approximately 2 litres of tap water into the
fresh water tank. Do not add detergents.
4. Press the spray switch to switch on the spray pump.
5. Hold the floor nozzle over a drain.
6. Operate the lever on the angle piece and flush the
device for 1 to 2 minutes.
7. Switch off the device.
Each time after use
1. Flush the device.
2. Drain the wastewater container and clean it under
running water.
3. Empty the fresh water tank.
4. Clean the exterior of the device with a damp cloth.
5. To avoid unpleasant smells, remove all water from
the device before long downtimes.
6. Let the device dry thoroughly: Remove the cover or
move it to the side.
Storing the device
1. Store the device in a dry room and secure it against
unauthorised use.

Cleaning methods

Normal soiling
1. Spray and vacuum up the cleaning solution in one
step.
Note
Repeated vacuuming without spraying shortens the dry-
ing time.
Heavily soiling or stains
1. Apply cleaning solution with the suction turbine
switched off and let it work for 10 to 15 minutes.
2. Clean the area as with normal soiling.
Upholstery cleaning
1. Puzzi 10/1 only: Fit the manual nozzle instead of the
floor nozzle.
2. Use less detergent for sensitive fabrics and spray
the surface at a distance of approx. 200 mm. Then
only vacuum.
Cleaning tips
● Spray heavily soiled areas in advance and allow the
cleaning solution to work for 5 to 10 minutes.
● Always work from light to shadow (from window to
door).
● Always work from the cleaned to the uncleaned ar-
ea.
● The more sensitive the covering (oriental bridges,
Berber, upholstery fabric) the lower the concentra-
tion of detergent.
● Carpets with jute backs can shrink and bleed in col-
our if the work is too wet.
● Brush wet pile carpets in the direction of the pile af-
ter cleaning when wet (e.g. with a fibre brush or
scrubber).
● Impregnating after wet cleaning prevents the textile
from being quickly soiled again.
● To avoid pressure points or rust stains, do not walk
on or furnish the cleaned area until after it has fully
dried.
12
● To improve the cleaning result, rinse the object with
clean water after using detergents.
Description
CarpetPro clean-
er (0.8 kg)
CarpetPro clean-
er, iCapsol (16
piece)
CarpetPro clean-
er, quick-drying
(10 litre)
CarpetPro clean-
er (10 litres)
CarpetPro im-
pregnation (5 li-
tres)
Defoaming (2.5 li-
tres)
For further information, please request the product in-
formation sheet and the EU safety data sheet for the rel-
evant cleaning agent.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
1. Place the suction pipe on the carrying handle for
transport and place the spray / suction hose on the
device. Wind up the mains cable and hang it in the
cable hook.
Illustration C
2. When transporting the device in vehicles, secure it
to prevent it from slipping or overturning in accord-
ance with the respective valid guidelines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
The device may only be operated indoors.

Care and service

DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
Clean the fluff filter
1. Remove the cover.
2. Remove the wastewater container from the device.
3. Clean the fluff filter regularly with a brush.
Clean the fresh water filter
1. Unscrew the fresh water filter.
2. Clean the fresh water filter under running water.
English
Detergent
Name Metering Order num-
ber
RM 760 1 % 6.295-175.0
powder
RM 760 2 tabs for 8 6.295-850.0
tabs litres
RM 767 liq- 1.2 % 6.295-198.0
uid
RM 764 liq- 1 % 6.295-854.0
uid
RM 762 liq- 20 % 6.295-852.0
uid
RM 761 liq- 0.5 % 6.291-389.0
uid
Transport
Storage