Cleaning Methods - Kärcher Puzzi 30/4 E Bedienungsanleitung

Removing the cover
1. Unlock the cover.
2. Swivel the cover backwards by 180° and pull it out.
Illustration H
Note
When inserting the cover, be careful not to damage the
guide pins.
Empty the wastewater container
1. When the wastewater container is full, switch off the
device by setting the turn switch to 0/OFF.
2. Unlock the cover, swing it upwards and latch it into
place at the locks.
3. Remove the wastewater container from the device
and empty it.
Emptying the fresh water tank
1. Switch off the device by setting the turn switch to 0/
OFF.
2. Briefly operate the lever on the angle piece to re-
lieve pressure.
3. Disconnect the angle piece from the spray / suction
hose.
4. Remove the fresh water tank cap.
5. Hang the suction hose in the fresh water tank.
6. Set the turn switch to vacuum. Suction turbine is
switched on.
7. Suck the fresh water tank empty and switch off the
device.
8. Empty the wastewater container.
Flushing the device
1. Connect the angle piece (with suction pipe and floor
nozzle) to the suction hose.
2. Connect the spray hose coupling to the angle piece
and latch into place.
3. Pour approximately 2 litres of tap water into the
fresh water tank. Do not add detergents.
4. Set the turn switch to spray. Spray pump is switched
on.
5. Hold the floor nozzle over a drain.
6. Operate the lever on the angle piece and flush the
device for 1 to 2 minutes.
7. Switch off the device by setting the turn switch to 0/
OFF.
Each time after use
1. Flush the device.
2. Remove the cover, unlock the filter casing and re-
move it. Clean the cover under running water.
3. Drain the wastewater container and clean it under
running water.
4. Empty the fresh water tank.
5. Clean the exterior of the device with a damp cloth.
6. To avoid unpleasant smells, remove all water from
the device before long downtimes.
7. Let the device dry thoroughly: Unlock the cover,
swing it upwards and latch it into place at the locks.
Remove the fresh water tank cap.
Storing the device
1. Place the floor nozzle in the rest and snap the suc-
tion pipe into the holder.
Illustration I
2. Store the suction hose and mains cable as shown in
the illustration.
3. Store the device in a dry room and secure it against
unauthorised use.
12

Cleaning methods

1. Spray and vacuum up the cleaning solution in one
step.
Note
Repeated vacuuming without spraying shortens the dry-
ing time.
Heavily soiling or stains
1. Apply cleaning solution with the suction turbine
switched off and let it work for 10 to 15 minutes.
2. Clean the area as with normal soiling.
Upholstery cleaning
1. Fit the manual nozzle (special accessories) instead
of the floor nozzle.
2. Use less detergent for sensitive fabrics and spray
the surface at a distance of approx. 200 mm. Then
only vacuum.
● Spray heavily soiled areas in advance and allow the
cleaning solution to work for 5 to 10 minutes.
● Always work from light to shadow (from window to
door).
● Always work from the cleaned to the uncleaned ar-
ea.
● The more sensitive the covering (oriental bridges,
Berber, upholstery fabric) the lower the concentra-
tion of detergent.
● Carpets with jute backs can shrink and bleed in col-
our if the work is too wet.
● Brush wet pile carpets in the direction of the pile af-
ter cleaning when wet (e.g. with a fibre brush or
scrubber).
● Impregnating after wet cleaning prevents the textile
from being quickly soiled again.
● To avoid pressure points or rust stains, do not walk
on or furnish the cleaned area until after it has fully
dried.
● To improve the cleaning result, rinse the object with
clean water after using detergents.
● Foam is generated in the wastewater container
when cleaning previously shampooed carpets. In
this case, add defoaming agent to the wastewater
container.
Description
CarpetPro clean-
er (0.8 kg)
CarpetPro clean-
er, iCapsol (16
piece)
CarpetPro clean-
er, quick-drying
(10 litre)
CarpetPro clean-
er (10 litres)
CarpetPro im-
pregnation (5 li-
tres)
Defoaming (2.5 li-
tres)
English
Normal soiling
Cleaning tips
Detergent
Name Metering Order num-
ber
RM 760 1 % 6.295-175.0
powder
RM 760 2 tabs for 8 6.295-850.0
tabs litres
RM 767 liq- 1.2 % 6.295-198.0
uid
RM 764 liq- 1 % 6.295-854.0
uid
RM 762 liq- 20 % 6.295-852.0
uid
RM 761 liq- 0.5 % 6.291-389.0
uid