Cleaning Methods - Kärcher Puzzi 10/1 Originalbetriebsanleitung

DANGER
Danger of electric shock
Risk of injury and damage.
The socket is only intended for the direct
connection of the PW 30/1 additional brush
washer head to the Puzzi 10/2 Adv. Any
other use of the socket is prohibited.
Switching on the device
1. Connect the mains plug.
2. Press the suction switch to switch on the
suction turbine.
3. Press the spray switch to switch on the
spray pump.
Cleaning mode
ATTENTION
Danger from cleaning solution
Risk of damage
Before using the device, check the object to
be cleaned for colour fastness and water
resistance in an inconspicuous place.
1. Press the lever on the angle piece to
spray the cleaning solution.
2. Run over the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
3. When work is interrupted, the floor noz-
zle can placed in the device carrying
handle.
Switching off the device
1. Switch off the spray switch and the suc-
tion switch.
2. Pull out the mains plug.
Empty the wastewater container
1. Switch off the suction switch and the
spray switch when the wastewater con-
tainer is full.
2. Remove the cover.
3. Remove the wastewater container from
the device and empty it.
Emptying the fresh water tank
1. Switch off the device.
2. Briefly operate the lever on the angle
piece to relieve pressure.
3. Disconnect the angle piece from the
spray / suction hose.
4. Hang the suction hose in the fresh water
tank.
14
5. Press the suction switch to switch on the
suction turbine.
6. Suck the fresh water tank empty and
switch off the device.
7. Remove the cover.
8. Remove the wastewater container from
the device and empty it.
Flushing the device
1. Connect the angle piece (with suction
pipe and floor nozzle) to the suction
hose.
2. Connect the spray hose coupling to the
angle piece and latch into place.
3. Pour approximately 2 litres of tap water
into the fresh water tank. Do not add de-
tergents.
4. Press the spray switch to switch on the
spray pump.
5. Hold the floor nozzle over a drain.
6. Operate the lever on the angle piece and
flush the device for 1 to 2 minutes.
7. Switch off the device.
Each time after use
1. Flush the device.
2. Drain the wastewater container and
clean it under running water.
3. Empty the fresh water tank.
4. Clean the exterior of the device with a
damp cloth.
5. To avoid unpleasant smells, remove all
water from the device before long down-
times.
6. Let the device dry thoroughly: Remove
the cover or move it to the side.
Storing the device
1. Store the device in a dry room and se-
cure it against unauthorised use.

Cleaning methods

Normal soiling
1. Spray and vacuum up the cleaning solu-
tion in one step.
Note
Repeated vacuuming without spraying
shortens the drying time.
English