Cleaning Methods - Kärcher SE 4002 Bedienungsanleitung

Start working
Illustration
 Insert the mains plug into the socket.
 Press the switch for suction (position I),
suction turbine is running.
Illustration
 Close fully the surrounding air separa-
tor at the handle.
Illustration
 Press the switch for spraying (position
I), the detergent pump is ready.
Illustration
 Use the lever on the spray handle to
spray on detergent solution.
Illustration
 For continuous spray, the spray lever
can be locked; for this, activate the
spray lever and pull the locking key to-
ward the rear.
 Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
Emptying the reservoir during
operation
Note: If the reservoir is full, a float closes
the suction opening, and the appliance
works at a higher speed.
 Switch the appliance off by pressing the
switch for suction and spraying
(position 0).
 Separate the spray/suction hose and
the spray hose from the appliance.
Note: Possibly remaining water can
drip out, therefore you should place
these into the shower or bathtub.
 Remove the accessories and the fresh
water reservoir and unlatch the motor
casing.
 Remove the motor casing and empty
the reservoir.
Cleaning tips/mode of operation
Always work from the light to the shade
–
(from the window to the door).
Always work from the cleaned to the un-
–
cleaned surface.
Rugs with jute backing can shrink if too
–
much water is used and can bleed col-
ours.
Brush high-fiber rugs in the direction of
–
the weave after cleaning (using a fiber
brush or a scrubber).
Water-proofing the fabric using Care Tex
–
RM 762 after the wet cleaning prevents
a quick resoiling of the textile surface.
Do not step on cleaned surfaces until
–
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.

Cleaning methods

Light/normal contamination
 Turn on suction and spraying
(position I).
 Spray and simultaneously suction off
detergent solution in one work cycle.
 Switch off the spray switch and suction
off the remaining cleaning solution.
 After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
Heavy soiling or stains
 Switch on sprayer (position I).
 Apply detergent solution and soak for 10
to 15 minutes (suction is switched off).
 Clean the surface just like you would
with light/normal soiling.
 After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
– 9
EN 17