CLIVET DUCT 2 ID3-XY Serie Handbuch Für Installation, Betrieb Und Wartung Seite 82

ALARM
For the input of ALARM connector CN33
Power
– The terminal input is set up for ALARM connection,
but there is no voltage; the power supply comes
from the ALARM system (not from the unit)
– Although the design voltage can withstand even
higher values, we strongly advise connecting a
power supply of less than 24 V and a current of
less than 0.5 A
– If this problem occurs on the unit, the relay will be
closed, thus activating the ALARM
OUTDOOR AIR FAN
For the input of terminal CN43 of the new outdoor air
motor.
– Connect the fan motor to the input, regardless of
the motor's L/N;
– The output voltage is the power supply;
– The outdoor air motor cannot exceed 200 W or 1A;
choose the lower value;
– The new outdoor air motor will start when the
internal fan motor is running; when this motor
stops, the outdoor air motor also stops;
– When the unit goes into forced cooling mode or
power test mode, the outdoor air motor will not
work.
32
2.5 Installation of the remote display
The remote display has a built-in signal receiver for
controlling the indoor unit with the remote control.
The remote display is supplied with the indoor unit but is
not connected to the board.
Proceed as follows to install and connect it.
1 Cut and remove the two pieces.
Fig. 41
2 Take the bottom off the remote display box.
Fig. 42
3 Remove the protective PVC. Fasten the bottom of the
display box with the two screws.
Installation
Fig. 43
Fig. 44
Fig. 45