Instructions for use
Fitting a cutting/grinding disc or other accessory
Use the correct type of disc. Only use cutting discs for cutting (fig.1 below)
and grinding discs for grinding (fig. 2 below).
Use only Ø 115 mm cutting discs and
grinding discs with 22 mm centre bores.
1. Remove the outer flange by pressing
in the spindle lock and undoing it with
the spanner.
2. Fit a grinding disc or other accessory
onto the inner flange, making sure that
it is properly centred and flat against
the inner flange.
3. Screw the outer flange back on. Hold
down the spindle lock and tighten
the flange using the included spanner.
4. Release the spindle lock and make
sure that the grinding disc/accessory
can rotate freely.
Fig 1
10
Fig 2