AsViva RA11 Benutzerhandbuch Seite 41

COMPUTER
6. PULSE:
Your computer displays your pulse rate during your workout (The range is from 40 to 220) If there is
no pulse signal or unstable pulse signal for over 8 seconds, the computer will show "P". (the computer
receiver built in)
7. RPM:
Show the times you stroke per minute. The computer shows RPM with pulse per each six seconds on
the same LCD window. The value range is from 15 to 999.If it is over 999, the window will show "E".
When there is no signal within 4 seconds, the value will reset to zero.
8. COUNT:
while during Roller mode the computer count once when the rod is back after your pull. And the compu-
ter accumulates this count from 0 to 9999.
Key function:
There are 3 button keys and the function description as follows:
1. UP key:
During the setting mode, press the key to increase the value of Time, Distance, Calories, etc. During
the CLOCK mode, you can set up clock by this key.
2. DOWN key:
During the setting mode, press the key to decrease the value of Time, Distance, Calories, etc. During
the CLOCK mode, you can set up clock by this key.
3. MODE key:
a. during the setting mode, Press the key to accept these setting values of TIME, DISTANCE and
CALORIE.
b. during the STOP mode, press the key to clear the exercising value or setting value to zero. c. during
the exercise mode, press the key to check the function from SCAN-TIME-SPEED- DIST-CAL-RPM-
PULSE for a circle.
NOTE:
1. Press Mode key for 2 seconds and the computer will re-power-on. The setting clock will reset to
zero.
Press the key to enter the setting mode during stop mode. When the computer switches to time, distan-
ce, calories, pulse mode, you can set the value during each mode by holding UP key and DOWN key.
Press Mode key again to turn to the next mode.
2. Setting and adjustment of Clock function:
The computer will enter Clock Setting mode after you power on it and all LCD windows
display. The hour will flash in the form of 0:.You can press UP and DOWN key to input the hour you
want. After you confirm your hour, press MODE key to enter the minute setting. The minute will flash
in the form of 00. You can press UP and DOWN key to input the minute you want. After you confirm
it, press MODE key to finish the clock setting. Then the computer turns to normal LCD display. Hold
MODE and UP key together for 2 seconds and you can enter the Clock setting mode. Then you can
change your clock setting by pressing mode key for 2 seconds.
41