Hi Power Operation - Toshiba RAS-10SKVP-ND Bedienungsanleitung

A1YPGTU/CPWCNA'0HO 2CIG  9GFPGUFC[ ,CPWCT[     2/

Hi POWER OPERATION

High power (Hi POWER)
• The Hi POWER (high power operation) mode automatically controls room temperature,
air flow and the operation mode so that the room is quickly cooled in summer and
warmed in winter. () see page 18.)
Setting Hi POWER mode
a Hi POWER button
Press the Hi POWER button. The Hi POWER mark on the remote controller is
shown.
Canceling Hi POWER mode
a Hi POWER button
Press the Hi POWER button once again.
The Hi POWER mark on the remote controller turns off.
CAUTION
The Hi POWER mode cannot be activated during DRY operation.
1, 3, 5, 9H OFF TIMER
The air conditioner stops after operating for the set time (1, 3, 5 or 9
hours).
a OFF button
Press the OFF button (during operation).
• There is a short beep and the timer indicator comes on. The time at which the air
conditioner will stop is indicated on the remote controller display (1H: about 1
hour after the current time).
• Press the button again while 1H is displayed (about 3 seconds) to change to the
3H indicator, press again to change to the 5H indicator, and press again to
change to the 9H indicator.
• After selecting the time you want, do not press this button again. (When the 1H,
3H, etc. indicator goes off the timer is set.)
b CLR button
Press the CLR button to cancel the timer.
• The timer is canceled but the air conditioner continues to operate.
• The 1, 3, 5 or 9H OFF timer operation is also canceled if the OFF button is
pressed after making a setting.
.
INFORMATION INFORMATION
• Cleaning operation starts when the time of the 1, 3, 5 or 9H OFF timer is reached.
(Cleaning operation is not performed during heating operation or the PURE
operation.)
• When using in combination with the ON timer, first set the 1, 3, 5 or 9H OFF timer
and then set the ON timer.
• If the OFF button is pressed while the ON (OFF) timer has been set, the ON (OFF)
timer is canceled and only the 1, 3, 5 or 9H OFF timer is set.
EN
12
a
b
a