Adjusting Air Flow Direction - Toshiba RAS-10SKVP-ND Bedienungsanleitung

A1YPGTU/CPWCNA'0HO 2CIG  9GFPGUFC[ ,CPWCT[     2/

ADJUSTING AIR FLOW DIRECTION

• Adjust the air flow direction properly. Failure to do so could cause discomfort
and make an uneven room temperature distribution.
• Adjust the vertical air flow using the remote controller.
• Adjust the horizontal air flow manually.
Adjusting the vertical air flow
The air conditioner automatically adjusts the vertical air flow direction according
to the operating conditions when AUTO or A mode is selected.
To set a selected air flow direction
Use this function when the air conditioner is operating.
a FIX button
Hold down or briefly press the FIX button on the remote controller to move
the louver in the desired direction.
• Change the vertical air flow louver direction within the range indicated.
• In subsequent operations, the vertical air flow is automatically set to the
direction that you set the louver using the FIX button.
To automatically swing the air flow direction
Perform this function when the air conditioner is operating.
a SWING button
Press the SWING button on the remote controller.
• To stop the function, press the SWING button.
• To change the swing direction, press the FIX button.
CAUTION
• The FIX and SWING buttons will be disabled when the air conditioner is not
operating (including when ON TIMER is set).
• Do not operate the air conditioner for an extended period of time with the air
flow direction set downward during the cooling or dry operation. Otherwise,
condensation may occur on the surface of the vertical air flow louver and
cause water dripping.
• Do not move the vertical air flow louver manually. Always use the FIX button.
If you move the louver manually, it may malfunction during operation.
If the louver malfunctions, stop the air conditioner once, and restart.
• When the air conditioner is started immediately after it was stopped, the
vertical air flow louver might not move for about 10 seconds.
Adjusting the horizontal air flow
Preparation:
• Grasp the lever on the horizontal air flow louver and move them to adjust the air
flow direction as required.
• You can adjust the air flow at the left and right locations of the grilles.
EN
16
a
a