Repositioning Of The Built-In Control Unit - Sawotec MN-23NB Bedienungsanleitung

REpoSITIoNINg of THE buILT-IN CoNTRoL uNIT

If you want to transfer the control unit to the other side (right or left):
1. Pull out the thermostat's knob (Fig. A) and open the screws, which are holding the
front cover.
2. Open the screws which are holding the control unit (Fig. B).
3. Pull outwards the control unit's upper edge and transfer the control unit to the
other side.
4. First mount the control unit's bottom-edge, noticing the small hooks there.
5. Then mount upper edge of the control unit very carefully and tighten the screws.
6. Make sure that the sensors are properly placed (Fig. C).
7. Put front cover and thermostat knob on their places.
13
ENGLISH