Inhaltsverzeichnis
Werbung
ELECTRICAL wIRING ANd INSTALLATIoN
A certified electrician must do the installation of the heater in accordance with applicable
local regulations to ensure safety and reliability of electrical connections. Improper elec-
trical connections can cause electric shock or fire. The connection cable must be of rubber
cable type H07RN-F or its equivalent.
NOTE: Using a PVC-insulated wire as connection cable for the Combi Heater is not allowed
because this material easily becomes brittle when subjected to heat.
Abb 7
ELECTRICAL DIAGRAM
Fig. 7
N U V N U
N
INSTALLATIoN of ExTERNAL CoNTRoL uNIT ANd SENSoRS
Innova Control Unit utilizes two sensors to power up the Combi heater. One is the Pri-
mary Temperature Sensor (TS1) and the other one is either the Secondary Temperature
Sensor (TS2) or the Temperature and Humidity Sensor (T/H). If the heater is placed
less than 200 mm from the wall, TS1 needs to be mounted on the wall above the heater
and must have a distance of 150 mm from the ceiling. However, if the heater is placed
more than 200mm from the wall, TS1 must be mounted to the ceiling over the heater,
as shown in the illustration. TS2 or T/H should be mounted on the wall opposite to the
heater and must have a distance between 300mm from the ceiling up to 1300mm from
the floor. See further details from control panel manual.
Abb 8
Anordnung des Sicherheitssensors
Fig. 8
Safety Sensor Location
L
R1
R2
a
L
E
B
evel
mpty
Level Empty
U1
TS2 or T/H
MNC-30NS
MNC-36NS
a
N
E
U
L
mpty
evel
B
R1 = Temperaturregler 1
R2 = Temperaturregler 2
R1 = Temperature Regulator 1
R2 = Temperature Regulator 2
TS1
IF NOT USING
SAWO INNOVA CONTROL
Transfer the jumper from
"a and U
" to "a and Level
B
" if NOT using SAWO
NOTE
Innova Control.
L = Temperaturbegrenzer
H# = Sauna-Heizelement
HS = Verdampfer-Heizelement
L = Temperature Limiter
H# = Sauna Heating Element
HS = Evaporator Heating Element
TS1
CEILING
FLOOR
ENGLISH
17
Werbung
Inhaltsverzeichnis
