Heater Stones; Loading Stones Into The Heater - Sawotec MN-23NB Bedienungsanleitung

HEATER SToNES

The main purpose of the stones in the heater unit is to store enough energy to effi-
ciently vaporize the water thrown on top of the stones to maintain correct humidity in
the sauna room. The stones must be removed at least once a year or every 500 hours
which ever occurs first. All stone crumbles must be removed from the heater unit and
replaced with new ones as described in the heater manual. When placing the stones,
recommended to use cut resistant gloves. The required amount of stones is also listed
in the manual provided. See page 11
NOTE! Never use the heater without stones as it may cause fire. Use only manufacturer
recommended stones. Using unsuitable stones may lead to heating element damage
and will void the warranty. Never use ceramic stones or other artificial stones of any
type!

LoAdINg SToNES INTo THE HEATER

It is recommended that all stones should be rinsed to remove any stains or dust that
can cause unpleasant odour during the first few times of using the heater. It is import-
ant that the stones are loaded carefully in a way that they do not block air circulation
through the heater. Larger stones that won't fit between the heating elements must
not be forced in place instead they must be completely removed.
Small crumble or stone pieces smaller than 35mm in diameter
must not be loaded into the heater because they will block the air
circulation and will cause overheating and possible heating ele-
ment damage.
NoTE! Heating element damage due to overheating caused by
wrong kind of stones or stones which were wrongly loaded into
the heater is not covered by the factory warranty.
Abb. 6
Fig. 6
15
ENGLISH