Inhaltsverzeichnis
Werbung
Lifting hose cylinder
For safety reasons the four rods which are mounted to the lifting hose cylinder must be pushed
through the bushes on the adapter of the lifting hose assy. Then fasten them with hex nuts.
The operator handle is now clamped between the lifting hose assy and the lifting hose cylinder.
5.3
Connection of lifting hose cylinder and suction pad
JUMBO 30 bis 120
Open the clamps (2) on the lifting hose cylinder (1) . Apply the suction pad. (4). Insert the hooks
into the lags on the suction pad and close the clamps .
JUMBO 200
Put the lifting hose cylinder (1) onto the suction pad (2), screw it with four bolts (3) and lock it with
hex nuts (4).
5280.0021
V3
1
2
3
4
1
4
3
2
22 / 28
GB
Werbung
Inhaltsverzeichnis
Fehlerbehebung
