Corrosion; Jaw Range; Jaw Change - SCHUNK KSC-D 80 Montage- Und Betriebsanleitung

_________________________________________________________________________________________
The KSC-D offers a host of attachment options on the supporting table that have all been
integrated into the device.
The following interfaces are included in the basic variant:
Fixing holes Ø9 to secure the unit using cylinder screws M8.
Positioning holes Ø12 H7 to positioning and fixing on grid plates with a size 50 and on T-slot
tables with fitting screws Ø12 f7/M12 or cylinder screws M12.
Locating holes Ø25 H6 for the clamping pin of the VERO-S quick-change palleting system.
Important:
When using VERO-S clamping bolts, make sure that a shortened screw is used, otherwise
the slide may be damage. (See Schunk catalogue)
Longitudinal grooves to attach clamping claws.
Attachment thread M4 in the base body for alignment using alignment and centring sets.
Threads M12 at the front on reference surface.
The KSC-D can also be produced at the factory with customer-specific positioning and fixing
holes as well as with location recesses for various commonly available quick-change palleting
systems.

4.2 Corrosion

The KSC-D's base body has been nickel-plated. Carriages and jaws are made of steel. Well-
maintained coolant is necessary to guarantee ideal functionality which must demonstrate
specified concentrations, pH values and conductivity properties.
Deviations from manufacturer data may lead to a formation of corrosion.

4.3 Jaw range

The reliable function of the clamping device is significantly affected by the selection of the
correct top jaws.

4.4 Jaw change

 Release cylinder screws and remove the jaws.
 Clean and oil the contact surfaces, e.g. with MOTOREX Supergliss 68 K to ISO VG 68.
 Changing the jaws or moving them in the carriages, tightened the cylinder screw (12.9) with a
torque of 60 Nm
schunk.com
.
XND.00034.002_B – 05/2022 24