Description Of The Clamping Device; Application; Adjusting Jaws - SCHUNK KSC-D 80 Montage- Und Betriebsanleitung

_________________________________________________________________________________________
3

Description of the clamping device

The KSC-D has been designed as a double vice to clamp two parts, raw parts and processed
workpieces.
The force is built up mechanically and applied using a left-hand and right-hand thread.
The power gear ratio is linear across the entire clamping range.
The entire vice has been encapsulated from the top and front and can be cleaned using
compressed air.
The third-hand operation function when clamping is guaranteed by pre-clamping the rear
carriage using a pressure spring.

3.1 Application

3.1.1 Adjusting jaws

For two identically sized or differently sized workpieces
Important:
The lateral clamping screw (pos. 200) has not been tightened, open by approximately ½ turn.
Fully open the vice and position the moving clamping jaws in the matching grooves of the
moving carriages depending on the workpiece size and tighten the cylinder screws with
property class 12.9 with torque 60 Nm.
Since the carriage have a maximum adjustment range of 31 mm, it is possible to clamp two
workpieces with different sizes. If this is insufficient, the system jaws can be moved by 25 mm
into another groove of the carriage.
schunk.com XND.00034.002_B – 05/2022 22