_________________________________________________________________________________________
12 Fixed jaw vise
The double vise can be used also as a fixed jaw vise.
Remove the middle jaw, the clamping and cylinder screw (Pos. 200 and 40) and slide
the carriage unit on the cylinder screw (Pos. 210).
To fix the carriage unit, the threaded pin (Pos. 230) must be clamped through the slider
into the counterbore in the base body with 20 Nm.
A cover for the area of the disassembled middle jaw is not included in the standard scope of
delivery of the double vise.
The disassembly to the double clamp is done in reverse order.
13 Taking out of service
The clamping device and all accessories can be disposed of as scrap metal without any risk.
schunk.com
XND.00034.002_B – 05/2022
31