Removal; Assembly - SCHUNK KSC-D 80 Montage- Und Betriebsanleitung

_________________________________________________________________________________________
7

Removal

Removing the carriage unit
 Removing the system jaws.
 Remove the cylinder screw. (pos. 210)
 Undo the clamping screw (pos. 200) by a minimum of 4 turns.
 Pull the entire carriage unit from the base body.
8

Assembly

Installing the carriage unit
 Fully contract the carriage unit.
 Push the carriage unit into the guide until it comes into contact with the other component.
Important:
Carriage unit must not come into contact with the rear cylinder screw. (pos. 210)
 Fully tighten the clamping screw (pos. 200) and undo by ½ turn.
 Install the front cylinder screw. (pos. 210)
 Install the system jaws in the carriages and tightened the cylinder screw (12.9) with a torque
of 60 Nm.
schunk.com XND.00034.002_B – 05/2022 26