Trouble Shooting; Transport, Storage, Maintenance And Disposal - Siko LE200 Originalmontageanleitung

LE200

Trouble shooting

6 Trouble shooting
Below are some typical errors which may occur during installation and
operation:
• Magnetic strip wrongly mounted, active side below (see chapter 4.2).
• The masking tape provided was not used for protecting the magnetic
• Magnetic sensor not or incorrectly connected (pin assignment see
• The distance tolerances were not observed over the whole measuring
• Cable squeezed / interrupted / cut by sharp edges.
• The magnetic sensor has been mounted with the active side turned
• Magnetic sensor has not been aligned according to

7 Transport, Storage, Maintenance and Disposal

Transport and storage
Handle, transport and store the magnetic sensor with care. Pay attention
to the following points:
• Transport and / or store the magnetic sensor in the unopened origi-
• Protect the magnetic sensor from harmful physical influences includ-
• Do not damage connections through mechanical or thermal impact.
• Prior to installation inspect the magnetic sensor for transport dam-
Maintenance
With correct installation according to chapter
requires no maintenance. Clean the surface of the magnetic strip with soft
cloth from time to time if it is very dirty.
Disposal
The magnetic sensor's electronic components contain materials that are
harmful for the environment and are carriers of recyclable materials at the
same time. Therefore, the magnetic sensor must be recycled after it has
been taken out of operation ultimately. Observe the environment protec-
tion guidelines of your country.
LE200 · Date 15.01.2020 · Art. No. 84882 · Mod. status 7/20
strip. The masking tape must not be magnetizable.
chapter 4.4).
length (see Fig. 6).
away from the band (see
nal packaging.
ing dust, heat and humidity.
ages. Do not install damaged magnetic sensors.
Fig. 6).
4
the magnetic sensor
English
Fig. 6.
25