Trouble Shooting; Transport, Storage, Maintenance And Disposal - Siko MSK2000 Originalmontageanleitung

MSK2000

Trouble shooting

3. If necessary, use a compass needle to determine the location of the
4. Use a rule and a sharp knife to cut the magnetic strip at a right angle.
5. Previous steps are to be repeated with the other part of strip.
6. Check polarity before joining the two parts. Both ends must attract
7. Join the two ends closely together and add the cover strip.
7 Trouble shooting
Below are some typical errors which may occur during installation and
operation:
• Magnetic strip wrongly mounted, active side below (see chapter 4.2).
• The masking tape provided was not used for protecting the magnetic
• Magnetic sensor not or incorrectly connected (pin assignment see
• The distance tolerances were not observed over the whole measuring
• Cable squeezed / interrupted / cut by sharp edges.
• The magnetic sensor has been mounted with the active side turned
• Magnetic sensor has not been aligned according to

8 Transport, Storage, Maintenance and Disposal

Transport and storage
Handle, transport and store the magnetic sensor with care. Pay attention
to the following points:
• Transport and / or store the magnetic sensor in the unopened origi-
• Protect the magnetic sensor from harmful physical influences includ-
• Do not damage connections through mechanical or thermal impact.
• Prior to installation inspect the magnetic sensor for transport dam-
MSK2000 · Date 07.02.2018 · Art. No. 81962 · Mod. status 44/18
poles on the magnetic strip (see
Then also cut the carrier strip accordingly.
each other (if necessary, use compass needle). In case both ends have
the same polarity, shorten one end by a half pole division (see
strip. The masking tape must not be magnetizable.
chapter 4.4).
length (see Fig. 6).
away from the band (see
nal packaging.
ing dust, heat and humidity.
ages. Do not install damaged magnetic sensors.
Fig. 8).
Fig. 6).
English
Fig. 9).
Fig. 6.
25