Test Run - hanseatic WQP8-7736B Gebrauchsanleitung

Adjusting the water hardness level
(12)
(13)
19. Close the dishwasher door.
20. If the dishwasher is switched on,
switch it off.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (1).
2. Press and hold the
LEDs (12) and
Please refer to the following table for the
relevant water hardness setting:
°dH LED display
0–5
6–11
12–17
18–22
23–34
35–55
3. Press the button (10) repeatedly until
the required hardness level is displayed.
(10)
button (10) until
(13) flash alternately.
Setting
H1
H2
H3
H4
H5
H6
Installation and connection
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The hardness level setting is saved.

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the de-
vice functions perfectly. Carry out this test run
when the dishwasher is empty and without
any dishwasher detergent.
1. Open the valve completely.
2. Close the dishwasher door.
3. Press the button (1) to switch on the
dishwasher.
You will hear a signal tone and all LEDs
will illuminate briefly.
After a moment, the ECO programme
LED will light up.
4. Press the P button (9) repeatedly until the
LED to the right of the
symbol lights up.
5. Start the programme with the button
(10).
The programme begins after a few sec-
onds.
6. Check for water leaks and unusual nois-
es.
7. When the programme is finished, an
acoustic signal will sound.
Switch the dishwasher off using the but-
ton (1).
8. Slightly open the door to allow the moist
air to escape.
9. Close the valve.
If no water has escaped and no unusual nois-
es have been heard, the dishwasher is ready
for operation and you can now load it with
dishes.
Page EN-29
programme