Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and connection
Choose a suitable location
The planned location must fulfil the following
prerequisites:
– The location must be a dry and frost-safe
room with a firm ground.
– The dishwasher must be positioned be-
neath a full work surface which is joined
together with the cupboards adjacent to the
dishwasher.
– In order to install the connection pipes, the
dishwasher must be positioned near to a
washing/dishwashing basin.
– The measurements of the recess must at
least correspond to the details in the follow-
ing diagram.
90°
820 mm
580 mm
Inlet/outlet area
and electrical con-
nection.
450 mm
CAUTION!
Risk of injury!
Improper handling of the appliance
may result in injury.
The appliance is heavy and bulky.
■
Seek the help of another person dur-
ing transport, installation and assem-
bly.
If a trolley is used to move the appli-
■
ance, the appliance must be moved
as shown on the packaging.
Only lift the appliance as shown on
■
the packaging.
Installation and connection
Remove all obstacles on the transport
■
route and from the installation loca-
tion, e.g. open doors and clear away
objects lying on the fl oor.
Having the outlet hose
connected
Connecting the outlet hose (22) to the trap
(siphon) of your washbasin/sink requires
specialist work.
For this reason, the outlet hose may only be
connected by a professional plumber or a
member of our service department (see „Ser-
vice" on page EN-35).
90°
Potential malfunction!
Failure to connect the appliance cor-
rectly may cause malfunctions during
80 mm
operation.
Make sure that the waste water can
■
100 mm
drain freely at any time. To that end,
the outlet pipe must have a minimum
diameter of 40 mm.
Ensure that there are no kinks or dam-
■
age to the outlet hose.
Make sure that the end of the hose is
■
not submerged in the pumped water.
Do not extend the outlet hose or re-
■
place with another drainage pipe.
NOTICE
Page EN-23
Werbung
Kapitel
Inhaltsverzeichnis
