Connecting The Inlet Hose; Connecting The Dishwasher To The Electricity - hanseatic WQP8-7736B Gebrauchsanleitung

Page EN-24 Installation and connection
Connect the outlet hose's outlet as follows:
Option A:
Direct connection to the odour seal (siphon)
of your washing/dishwashing basin. The out-
let hose must be a maximum of 1000 mm
above the floor.
Option B:
Connection to a floor drain.

Connecting the inlet hose

NOTICE
Risk of damage!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be able
to run freely into the dishwasher, oth-
erwise this can damage the appliance.
For water pressure of less than 10 bar,
■
install a pressure reducer (in case of
doubt, seek information from the wa-
ter supply company).
Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (e.g. continuous fl ow heat-
er, pressure-free boiler etc.).
Ensure that the inlet hose is correctly
■
connected and is not kinked or dam-
aged.
Ø ≥ 40 mm
Do not damage the inlet hose; it con-
■
tains electrical components. If the
inlet hose is damaged, contact our
service department (see „Service" on
page EN-35).
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve lock nut to the tap
hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping
from the connection. Then close the valve
again.
Connecting the dishwasher to
the electricity
WARNING!
Electric shock / fi re hazard!
Prior to connecting the dishwasher,
■
ensure that you have taken note of all
the safety instructions and adhered
to them (see page EN-6).
Depending on the recess into which the dish-
washer will be fitted, the dishwasher should
be connected before or after fitting.
– A properly installed, earthed power sock-
et with its own fuse of a sufficient size
(230 V~/50 Hz/10 A) is required to connect
the dishwasher to the electricity supply.