hanseatic WQP8-7736B Gebrauchsanleitung Seite 62

Page EN-26 Installation and connection
5. Remove the protective films from the
side end profiles (c).
6. Affix the end profiles to the left and right
edges of the dishwasher. This will pre-
vent a crack being visible between the
dishwasher and the adjacent kitchen
cupboards.
7. Push the dishwasher into the recess.
8. The height of both front feet and the
back foot of the appliance can be adjust-
ed in order to level the dishwasher.
The front feet are equipped with slots.
Insert a screwdriver into one of the slots
and turn the feet to the height required.
9. You can adjust the height of the back
foot with the centre adjusting screw. Use
a Phillips-tip screwdriver for this.
10. Check the alignment with a spirit level.
11. Make sure the top edge of the dishwash-
er is level with the bottom edge of the
(c)
worktop to prevent it from tipping forward
when you open the dishwasher door.
12. Screw the dishwasher to the kitchen
unit.
a) If you have granite worktops, remove
the internal cover caps (h) from the
sides and screw the dishwasher to the
adjacent kitchen cupboards at these
points.
Cover the screws (i) again with the
cover caps.
b) For all other worktops, screw the
mounting bracket (g) to the work sur-
face until it is fixed.
(g)
(j)
(h) (i)