Dishwasher Operation; Preparation; Select The Wash Programme And Start; Additional Options - hanseatic WQP8-7736B Gebrauchsanleitung

Page EN-18

Dishwasher operation

Dishwasher operation

Preparation

1. Open the valve completely.
2. Close the dishwasher door.
3. Press the button (1) to switch on the
dishwasher.
You will hear a signal tone and all LEDs
will illuminate briefly.
After a moment, the ECO programme
LED will light up.
Select the wash programme
and start
1. Find the right wash programme with the
aid of the "Wash programme table", see
page EN-17.
2. Press the P button (9) repeatedly until
the LED to the right of the desired pro-
gramme symbol lights up.
3. Press the button (10) to start the wash
programme.
The LED to the right of the programme
symbol will flash while the programme is
running.
4. Once the programme has finished, a
signal tone will sound and the LED to the
right of the programme symbol will stop
flashing.
Now turn off the water tap and press the
button (1) to switch off the dishwasher.
5. Wait a little while before unloading the
dishes.

Additional options

You can combine the various wash pro-
gramme (6) with additional options. The
additional options must be selected before
starting the wash programme.
Delayed start
The wash cycle normally starts as soon as
you press the
can delay the start of the programme by 3, 6
or 9 hours.
(9) (10)
1. Press the "Delayed start" button (8) re-
peatedly until the LED to the left of the
desired delay lights up.
2. Press the button
The LED to the left of the delay will now
flash.
The programme will start as usual after
the delay period has finished.
Half load
Select the "Half load" option if you would like
to run the dishwasher with 6 place settings
or less. This additional option reduces water
and power consumption.
button (10). However, you
(10)
(8)
(10).