Adding Dishwasher Salt - hanseatic WQP8-7736B Gebrauchsanleitung

Dishwasher detergents, rinse aids and dishwasher salts
1. Turn the cover of the rinse aid dispenser
(20) a quarter of a turn anticlockwise and
remove it.
2. Fill the water tank to the "max" mark in the
opening. The adjacent inspection window
turns black.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. We recommend that you do not change
the dosing amount set in the factory at
first. Only correct the dosage if you are
not satisfied with the rinsing results (see
below).
5. Place the dispenser cover back over the
opening and rotate it clockwise to close it.
Changing the rinse aid dosage
If, after washing, the dishes are
– dull and stained, increase the dosage by
turning the arrow on the rinse aid dispenser
(20) to a higher value.
– sticky and smeared, decrease the dosage
by turning the arrow on the rinse aid dis-
penser (20) to a lower value.

Adding dishwasher salt

NOTICE
Risk of damage!
You may damage the dishwasher and
its stainless steel surface by using dish-
washer salt in an improper manner.
Only use regenerating salt which is
■
specifi cally intended for dishwashers.
Always wipe away split dishwasher
■
salt immediately with a damp cloth.
Immediately after adding the dish-
■
washer salt, launch a wash pro-
gramme.
You do not need to add dishwasher salt
to the dishwasher salt dispenser
– if you are only using multitabs which al-
ready contain dishwasher salt,
– if the water hardness in your area is in the
0–5° dH range.
Add dishwasher salt:
– prior to using the dishwasher for the first
time,
– if the control display "Add dishwasher salt"
(13) lights up.
(19)
1. Remove the lower dish rack (16).
2. Turn the cover on the dishwasher salt dis-
penser (19) anticlockwise and remove it.
3. Upon first use: Add 1.5 l water to the dish-
washer salt dispenser so that the dish-
washer salt does not clump.
(d)
4. Place the supplied filling funnel (d) on the
compartment opening.
5. Add dishwasher salt up to the edge of the
compartment.
6. Stir the dishwasher salt using the end of a
spoon or similar.
7. Turn the cover of the dishwasher salt dis-
penser (19) clockwise up to the stop.
8. Replace the lower dish rack (16).
9. Start a wash programme straight away or
carry out a test run when using for the first
time (see „Test run" on page EN-31).
Page EN-13