Connecting The Inlet Hose - hanseatic HGU4582D97710DI Gebrauchsanleitung

B
A
Ø 40 mm
The outlet hose (25) can be connected in two
ways:
– Option A:
Connection to a floor drain.
– Option B:
Direct connection to the odour seal (siphon)
of your washing/dishwashing basin. The
outlet hose must be a maximum of 1000 mm
above the floor. Technical measures must
be taken for connection. For this reason,
only plumbing experts or members of our
service team may connect the outlet hose
(see page EN-40).
There is a washer in an unused exhaust
manifold that prevents water from es-
caping here. This washer must be re-
placed by a seal ring before connecting the
outlet hose.
Installation, fitting, connection

Connecting the inlet hose

NOTICE
Risk of damage to property!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be
able to run freely into the dishwasher,
otherwise this can damage the
appliance.
For water pressure of less than 10
■
bar, install a pressure reducer (in case
of doubt, seek information from the
water supply company).
Never connect the appliance to the
■
water tap or the mixing arm of a
water heater (e.g. continuous fl ow
heater, pressure-free boiler etc.).
Do not cut through the inlet hose un-
■
der any circumstances if the mains
plug of the dishwasher is in the socket.
If the inlet hose is damaged, contact
our service team (see page EN-40).
Ensure that the inlet hose is correctly
■
connected and is not kinked or
damaged.
3
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the union nut of the inlet hose to
the water tap until it is tight.
Page EN-29
¾ inch
Inlet hose with
rubber seal