Steinbach Poolrunner Battery Pro Originalbetriebsanleitung Seite 32

Fault description
The device does not completely
move up the wall.
The device does not sink.
The device rises to the surface.
If the problem cannot be solved, contact the customer service listed on the last page.
32
Cause
The filter is clogged.
Algae grows on the walls.
The water temperature is too high or
too low.
The tires or the cleaning roller are/is
worn.
The device is too light and topples.
The pH value and the chlorine
quantity are not properly set.
There is air in the device.
The salt content is too high and the
device has more buoyancy.
The device climbs too high or there
is air trapped in the device.
The salt content is too high and the
device has more buoyancy.
Remedy
Clean the filter.
Manually pre-clean the pool walls.
Investigate and remedy the cause of
algae growth (e.g., pH value). Use
the pool cleaner more frequently.
Operate the device at water
operating temperature (see section
"Technical data").
Check the tires and the cleaning
roller for wear and replace them if
necessary.
Switch off the device and let all the
air escape.
Adjust the pH value and the chlorine
value to the correct value (see
section "Technical data").
Switch off the device and let all the
air escape.
Set the correct salt content. See
section "Technical data".
Switch off the device and let all the
air escape.
Set the correct salt content. See
section "Technical data".