Steinbach Poolrunner Battery Pro Originalbetriebsanleitung Seite 27

Inserting the filter
3
7
1. Open the hatch .
7
2. Position the filter unit
channel.
3. Close the hatch so that it locks in place.
7
The filter is inserted.
Placing the device in the pool and starting cleaning
You can use the device as delivered without using the app. Optionally, you can also optimize the preset
cleaning program to suit your individual requirements (see section "Description"). The desired settings
must be made before operation and outside the water; they are saved and can be used afterwards.
6
6
1. Check that the cap is securely snapped onto the charging socket.
2. Switch the ON/OFF switch
The status indicator
3. Hold the device by the handle and lower it slowly into the water until all the air has escaped.
4. Then let the device sink to the bottom of the pool.
Make sure that the device lands on the bottom of the pool on its underside and that cleaning can
start without obstruction towards the center of the pool.
The status indicator
on the suction
8
4
to ON.
6
is lit blue. The device is switched on and ready for operation.
4
blinks blue.
4
4
5
7
8
7
27