Storage; Troubleshooting - Steinbach Poolrunner Battery Pro Originalbetriebsanleitung

2. Thoroughly rinse the filter unit with plain tap
water.
3. Close the cover of the filter unit so that it
9
locks in place.
The filter is cleaned.

Storage

1. Thoroughly clean the device (see section "Cleaning").
2. Let all parts dry completely.
3. Fully charge the device.
Recharging is required after at latest 3 months due to self-discharge.
4. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C) without direct
sunlight.

Troubleshooting

Fault description
Charger blinks red.
The status indicator blinks red.
4
The device cannot reach all places
in the pool.
12
13
9
Cause
Low rechargeable battery voltage or
faulty rechargeable battery.
Device is out of the water.
The water circuit of the pool is
switched on.
The device becomes stuck on the
drain grate.
Remedy
Contact customer service.
Place the device in the water or
switch it off if you are not going to
use it at present.
Switch off the filter system of the
pool.
Switch off the filter system of the
pool.
31