Filling Water Tank; Selecting Temperature Setting For Iron; Automatic Shut-Off; Spray Function - Silvercrest SDB 2200 A1 Bedienungsanleitung

__RP58929_B3.book Seite 5 Montag, 1. November 2010 8:40 08
can simply continue ironing while the appli-
ance heats up.

4.1 Filling water tank

DANGER: When filling up the
water tank 8, unplug the appli-
ance at the wall socket.
• Only use clean tap water without add-
ing anything to it (e.g. vinegar, des-
caler, starch, scent, fabric softener).
• The built-in Anti-scale system reduces
scale build-up with average water
hardness, so extending the life of your
iron. If the tap water in your area is
hard, use distilled water. If the water is
moderately hard, mix distilled water
and tap water in a ratio of 1:1.
1. Disconnect the power plug from the
wall socket.
2. Turn the steam level controller 13 to
.
3. Open the lid 12 of the water
tank and hold the appliance
at an angle to fill.
4. Use the measuring beaker 16 to fill up to
the max 6 mark (however, so tank is at
least a quarter-full). To check, hold the
steam iron horizontally.
5. Close the lid 12 of the water tank.
6. Set the steam iron into a vertical posi-
tion.
4.2 Selecting temperature set-
ting for iron
1. Use the temperature controller 9 to
select the required temperature:
MIN Appliance does not heat up
Temperature: up to approx. 110 °C
Temperature: up to approx. 150 °C
Temperature: up to approx. 210 °C
MAX Maximum temperature
2. The temperature control lamp 5 lights
up as long as the steam iron is heating
up. It is extinguished when the selected
temperature is reached. You can then
start work.

4.3 Automatic shut-off

The automatic shut-off feature switches off
the heating when...
... you put the appliance down horizon-
tally on the soleplate 7 and do not use
it for approx. 30 seconds.
... the appliance is not used for approx.
8 minutes when in a vertical position.
A short acoustic alarm signal is heard, and
the pilot light 1 on the handle 2 starts to
flash.
• Hold the appliance horizontally and
move it to continue ironing.

4.4 Spray function

The spray function is used to moisten dry
laundry. It is available whatever tempera-
ture setting you have selected. Here the-
water tank 8 has to be at least a quarter-
full.
• Press the Spray button 14
times while holding the iron horizon-
tally over the item of laundry. Make
sure no water sprays on the ground.
several
5
GB