Herunterladen Inhalt Inhalt Diese Seite drucken

Storz C-MAC 8403 ZX Gebrauchsanweisung Seite 34

Inhaltsverzeichnis

Werbung

28
Bedienung
1
HINWEIS: Der C-MAC
®
Monitor kann
sowohl mit Netzstrom als auch über den
eingebauten Akku betrieben werden.
Das Aufladen des Akkus erfolgt automatisch,
sobald der Monitor mit dem Netz verbunden ist.
Dies wird durch das Leuchten der orangefarbenen
LED angezeigt.
1
HINWEIS: Der Monitor sollte nach jedem
Gebrauch oder spätestens nach Absinken
des Ladezustands unter 50% wieder
aufgeladen werden.
2
VORSICHT: Beschädigung des Netz-
kabels: Zum Entfernen des Netzkabels aus
der Steckdose nur am Steckergehäuse
ziehen, keinesfalls am Kabel.
Der Lithium-Ionen-Akku ist in geladenem Zustand
ca. 2 Stunden einsatzbereit.
Der entladene Akku ist nach 5 Stunden (bei ausge-
schaltetem Gerät) vollständig aufgeladen. Während
der Ladezeit leuchtet die orangefarbene LED.
Wird das System 12 Wochen oder länger nicht
benutzt, sollten Sie die Ladung anhand der
Seite 11 aufgeführten Ladebalken überprüfen und
ggf. laden.
Operation
1
NOTE: The C-MAC
®
Monitor can be
powered using either mains electricity or
the integrated battery.
The battery is charged automatically as soon as the
monitor is connected to the power supply. This is
displayed by the lighting up of the orange-colored
LED.
1
NOTE: The monitor should be recharged
after each use or, at the latest, once the
charge state has dropped below 50%.
2
CAUTION: Damage to the power cord: To
remove the power cord from the socket,
pull only on the plug housing, never on the
cord itself!
The lithium-ion battery can be used for approx. 2
hours when charged.
The discharged battery is fully charged after 5
hours (when the device is switched off). During the
charging time, the orange-colored LED lights up.
If the system is not used for 12 weeks or longer,
auf
you should check the charge state using the
progress bar
described on
page 11 and, if
necessary, charge.
Manejo
1
NOTA: El monitor C-MAC
®
puede usarse
con corriente de la red, así como por
medio del acumulador integrado.
La recarga del acumulador se realiza
automáticamente en cuanto se conecta el monitor
a la red. Esto se indica mediante el encendido del
LED naranja.
1
NOTA: El monitor debe recargarse
después de cada utilización o, a más
tardar, cuando el estado de la carga sea
inferior al 50%.
2
ADVERTENCIA: Deterioro del cable de
red: Para extraer el cable de red de la toma
de corriente, tire únicamente del enchufe,
nunca del cable.
El acumulador de iones de litio cargado puede
utilizarse durante aprox. 2 horas.
El acumulador descargado tarda 5 horas (con
el equipo apagado) en cargarse de nuevo
completamente. Durante el tiempo de carga está
encendido el LED naranja.
Si no usa el sistema durante 12 semanas o más,
compruebe la carga consultando las barras de
carga
detalladas en la
página
11,
y si es necesario,
cargue el sistema.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis