VOLTCRAFT EMZ-1000 Bedienungsanleitung Seite 32

• Observe the safety and operating instructions of any other devices you intend to
connect to the device, in addition to those contained in the individual chapters of
these operating instructions.
• The measurement device and its accessories are not toys and must be kept out
of the reach of children.
• For installations in industrial facilities, follow the accident prevention regulations
for electrical systems and equipment issued by the national safety organisation or
the corresponding national authority.
• In schools, educational facilities, hobby and DIY workshops, measuring devices
must be operated under the responsible supervision of qualified personnel.
• Never switch the device on immediately after moving it from a cold to a warm
environment. The condensation generated may destroy the product. Leave the
device switched off and allow it to reach room temperature.
• Handle the product carefully. The product can be damaged if crushed, struck or
dropped, even from a low height.
• Do not leave packaging material lying around carelessly. It may become a danger-
ous toy for children.
• Do not dismantle batteries, do not short-circuit them or throw them into a fire.
Never attempt to recharge disposable batteries. There is a risk of explosion.
• To prevent battery leakage, remove the batteries if you will not use the product
for an extended period of time. Leaking or damaged batteries may cause acid
burns if they come into contact with your skin. Always use protective gloves when
handling damaged batteries.
• Keep batteries out of the reach of children. Do not leave batteries lying around, as
there is risk that children or pets swallow them.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Never pour out liquids above electrical appliances and never leave objects filled
with liquids (e.g. glasses) in the vicinity.
• The voltage between the connection points of the tester and earth potential must
not exceed 150 V DC/AC in CAT IV or 300 V DC/AC in CAT III.
32