Operating Requirements; Input Signal Requirements - Tektronix 5-Serie Schnellstart-Benutzerhandbuch

Operating requirements

Use the instrument within the required operating temperature, power, altitude, and signal input voltage ranges to provide the most accurate
measurements and safe instrument operation.
Table 1: Environment requirements
Characteristic Description
Operating temperature 0 °C to +50 °C (+32 °F to +122 °F)
For proper cooling, keep the sides and rear of the instrument clear of obstructions for 2 inches (51 mm).
Operating humidity 5% to 90% relative humidity (% RH) up to +40 °C (+104 °F), non-condensing.
5% to 55% RH above +40 °C up to +50 °C (+104 °F to +122 °F), non-condensing.
5% to 90% RH at temperatures up to +60°C (+140°F), non-condensing, and as limited by a maximum
wet-bulb temperature of +39°C (+102°F).
Operating altitude Up to 3000 meters (9842 feet)
Table 2: Power requirements
Characteristic Description
Power source voltage 100 V - 240 V
Power source frequency 50/60 Hz, 100-240 V
400 Hz, 115 V
Power consumption 400 W maximum

Input signal requirements

Keep the input signals within allowed limits to ensure the most accurate measurements and prevent damage to the analog and digital
probes or instrument.
Make sure that input signals connected to the instrument are within the following requirements.
Input
Analog input channels, 1 MΩ setting,
maximum input voltage at BNC
Analog input channels, 50 Ω setting,
maximum input voltage at BNC
Digital input channels, maximum input
voltage range at digital inputs
Ref In maximum input voltage at BNC (rear
panel)
Aux In trigger input
5 Series B Mixed Signal Oscilloscopes MSO54B, MSO56B, MSO58B Quick Start Manual
, ±10%, single phase
AC RMS
Description
300 V
RMS
Measurement Category II
5 V , at 100 mV/div, with peaks ≤ ±20 V (Pulse Width ≤200 us)
RMS
Measurement Category II
Observe probe ratings
TLP058; ±42 V
P
7 V
PP
±5 V
RMS
Installing your instrument
15