Disposal And Recycling - Scheppach HMS1080 Original Bedienungsanleitung

• Place the blade adjustment block (18), as shown
in Figure 18, on the knife block. Make sure that the
knife (25) touches both sides of the blade adjust-
ment block (18).
• By the two set screws (26), the knife can be adjusted
for height.
• After a successful knife setting, all clamping screws
must be tightened
Please mind:
• Sharp planer/thicknesser knives guarantee a clean
planing surface and put less stress on the motor.
• After three grinding actions, a maximum material re-
moval of 3 x 0.05 mm may not be exceeded.
• The planer/thicknesser blades used on this machine
are not suitable for rebating and dovetailing.
• Finally lower the cutter block guard again onto the
table. Cover the cutter block and block it with the
star grip screw.
m IMPORTANT!
Only use knives which are recommended by the man-
ufacturer for this equipment. If you use other knives
there is a risk of injuries due to lack of control.
Avoid over-tightening and the possibility of the thread
becoming detached. If the latch (22) or the screws
have worn out threads they must be immediately re-
placed.
Connections and repairs
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: Planer blades, motor drive belt, carbon
brushes
* Not necessarily included in the scope of delivery!
34 | GB

14. Disposal and recycling

special waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product
must be disposed of at a designated collection point.
This can occur, for example, by handing it in at an au-
thorised collecting point for the recycling of waste
electrical and electronic equipment. Improper handling
of waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.
www.scheppach.com
The equipment is supplied in packaging to
prevent it from being damaged in transit.
The raw materials in this packaging can be
reused or recycled. The equipment and its
accessories are made of various types of
material, such as metal and plastic. Defec-
tive components must be disposed of as