Ordering Spare Parts; Transport; Storage; Disposal And Recycling - Scheppach PLM1800 Original Bedienungsanleitung

13.2 Maintenance
13.2.1 Machine (fig. 21 + 22)
Periodically lubricate the following parts about every
10 operating hours:
• Anti-return claws (42)
• Threaded rod for adjusting the height of the planer
(43)
• Guide columns for height adjustment (44)
Use only dry lubricant.
The feed table, discharge table, planing table, feed/
discharge rollers and anti-return claws must always
be kept free from resin. Soiled feed/discharge rollers
or anti-return claws must be cleaned. To prevent the
motor from overheating, dust that settles in the ventila-
tion openings must be removed on a regular basis. Im-
prove the sliding capability of the table by periodically
treating it with a lubricant.
13.2.2 Cutting tool
Blade, terminal strip and planing shaft must be kept
free from resin. Clean these with an appropriate resin
remover.

13.3 Ordering spare parts:

Please provide the following information when order-
ing spare parts;
• Device type
• Device article number
• Device ID number
• Spare part number of the required spare part
Repairs and work that has not been described in these
instructions may only be carried out by qualified spe-
cialists.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: V-belt, Carbon brushes, Planing blade,
Push stick, Rubber rollers
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

14. Transport

Only transport the machine with the 2 handles. (7)
Disconnect the machine from the mains to transport.

15. Storage

Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing tem-
perature. The ideal storage temperature is between 5
and 30 °C.
Store the electric tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.

16. Disposal and recycling

The unit is supplied in packaging to prevent
its being damaged in transit. This packaging
is raw material and can therefore be reused
or can be returned to the raw material system.
The unit and its accessories are made of var-
ious types of material, such as metal and plas-
tic. Defective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste electri-
cal and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.
www.scheppach.com GB | 35