Introduction; Device Description - Scheppach HMS1080 Original Bedienungsanleitung

1.

Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
we wish you a pleasant and successful working experi-
ence with your new scheppach machine.
Note:
According to the applicable product liability law the
manufacturer of this device is not liable for damages
which arise on or in connection with this device in case
of:
• improper handling,
• non-compliance with the instructions for use,
• repairs by third party, non authorized skilled work-
ers,
• installation and replacement of non-original spare
parts,
• improper use,
• failures of the electrical system due to the non-com-
pliance with the electrical specifications and the
VDE 0100, DIN 57113 / VDE 0113 regulations
Recommendations:
Read the entire text of the operating instructions prior
to the assembly and operation of the device.
These operating instructions are intended to make it
easier for you to get familiar with your device and uti-
lize its intended possibilities of use.
The operating instructions contain important notes on
how to work safely, properly and economically with
your machine and how to avoid dangers, save repair
costs, reduce downtime, and increase the reliability
and working life of the machine.
In addition to the safety regulations contained herein,
you must in any case comply with the applicable regu-
lations of your country with respect to the operation of
the machine.
Put the operating instructions in a clear plastic folder
to protect them from dirt and humidity, and store them
near the machine. The instructions must be read and
carefully observed by each operator prior to starting
the work. Only persons who have been trained in the
use of the machine and have been informed on the
related dangers and risks are allowed to use the ma-
chine. The required minimum age must be met.
In addition to the safety notes contained in the present
operating instructions and the special regulations of
your country, the generally recognized technical rules
for the operation of wood working machines must be
observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description

1. Overload switch
2. On/off switch
3. Plunger
4. Star grip screw with washer M6
5. Chip extraction
5a. Chip extraction extension
6. Fastening nut M6
7. Take-off table
8. Parallel fence
8a. Locking screw
9. Planing blade cover
9a. Swivel arm for planing blade cover
10. Fastening nut M6
11. Knurled screw M8
12. Crank handle
13. Adjusting screw
14. Feed table
15. Rubber feet
16. Push stick
17. Push block
18. Blade adjustment block
19. Philips screw M5
20. Anti-return claws
21. Planing table
22. Threaded spindle
23. Clamping screw
24. Cutter bar
25. Planing blade
26. Set screw
A. Hexagon socket screw M8
B. Washer
C. Hexagon socket screw M6
D. 4 mm Allen key
E. 5 mm Allen key
F. 6 mm Allen key
G. Scale (thickness plane)
H. Scale (infeed)
I. Scale (parallel stop)
www.scheppach.com GB | 25