Introduction; Layout - Scheppach PLM1800 Original Bedienungsanleitung

1.

Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Str. 69
D - 89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the de-
vice. The operating instructions are intended to help
the user to become familiar with the machine and take
advantage of its application possibilities in accordance
with the recommendations.
The operating instructions contain important infor-
mation on how to operate the machine safely, profes-
sionally and economically, how to avoid danger, costly
repairs, reduce downtimes and how to increase relia-
bility and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information.
26 | GB
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated dan-
gers. The minimum age requirement must be complied
with.
In addition to the safety instructions contained in this
manual and the specific country regulations the gener-
ally accepted technical rules must be observed for the
operation of woodworking machines.
We cannot accept any liability for damage or accidents
which arise due to a failure to follow these instructions
and the safety instructions.

2. Layout

1. Machine housing
2. Workpiece return rollers
3. Covering cap for crank
4. Height adjustment crank
5. Suction adapter
6. Discharge table
7. Handle
8. Scale pointer
9. Height scale
10. Machine base
11. Mounting holes
12. Feed table
13. Carbon brush cover
14. Cutting depth measurement
15. Planing table
16. Planer
17. Overload switch
18. On/off switch
19. Mains cable
20. Knurled screw for suction hose
21. Magnet
22. Allen key
23. Washer
24. Hexagon socket screw
25. Suction port
26. Crank receptacle
27. Suction hose
28. Push stick
29. Transport protection
30. Protective foil
31. Push stick holder
32. Magnet holder
33. Allen key holder
34. Planing shaft cover
35. Planing shaft cover hexagon socket screw
36. Planing blade screw fitting
www.scheppach.com