Troubleshooting The Charger - Stihl SEA 20 Gebrauchsanleitung

English
Fault LEDs on the hand
vacuum
The suction power 1 LED flashing
of the hand vacuum green.
decreases.
Hand vacuum
runtime is too short.

17.2 Troubleshooting the Charger

Fault LED on Charger
Battery not being One LED glows
charged. red.
The LED flashes
red.
The charger does not The LED glows
run a self test. green for about
1 second and then
red for about
1 second.
50
Cause
State of charge of the
battery is too low.
The container is full.
The battery is not fully
charged.
The battery service life has
been exceeded.
Cause
The battery is too warm or
too cold.
No electrical contact
between charger and
battery.
There is a malfunction in
the charger.
There is a fault in the
battery.
Electrical contact to
charger was briefly
interrupted.
Remedy
► Charge the battery.
► Remove the battery.
► Empty the container.
► Clean the hand vacuum.
► Fully charge the battery.
► Replace battery.
Remedy
► Leave battery inserted in charger.
Charging starts automatically as soon as the
permitted temperature range is reached.
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
► Do not use the charger and contact your STIHL
dealer for assistance.
► Do not use the battery. Consult a STIHL dealer.
► Disconnect the mains plug from the power supply.
► Wait for 1 minute.
► Insert the mains plug in a wall outlet.
17 Troubleshooting
0458-006-9621-A