Displaying State Of Charge; Leds On The Hand Vacuum; Led On Charger - Stihl SEA 20 Gebrauchsanleitung

English
The charging process starts automatically
when the mains plug is plugged into a socket
and the battery is inserted into the charger.
The charger switches off automatically when
the battery is fully charged.
The battery and the charger warm up during charging.
1
3
► Insert the mains plug (5) in a convenient wall outlet (6).
The charger (2) runs a self test. The LED (3) glows green
for about 1 second and then red for about 1 second.
► Fit the connecting cable (4).
► Insert the battery (1) in the guides in the charger (2) and
press it home as far as stop.
The LED (3) glows or flashes green. The battery (2) is
being charged.
► When the LED (3) stops glowing: The battery (1) is fully
charged and can be taken out of the charger (2).
► If the charger (2) is no longer required. Disconnect the
mains plug (5) from the wall outlet (6).
42
2
5 6
4
6.3

Displaying State of Charge

1
► Insert battery.
► Press the button (1).
The LEDs emit green light for about 5 seconds and
indicate the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.4

LEDs on the hand vacuum

The LEDs can indicate the state of charge of the battery or
any faults. The LEDs can be steady green, steady red or
flashing.
If the LEDs are steady or flashing green, this indicates the
state of charge of the battery.
► If the LEDs glow or flash red: Troubleshooting, @ 17.1.
Malfunction in hand vacuum or battery.
6.5

LED on Charger

The LED indicates the operating status of the charger or
faults. The LED can glow or flash green or red.
If the LED glows or flashes green, the battery is being
charged.
► If the LED glows or flashes red: Troubleshooting, @ 17.
There is a malfunction in charger or battery.
6 Charging the Battery, LEDs
80-100%
60-80%
40-60%
20-40%
0-20%
0458-006-9621-A