Troubleshooting; Remedying Faults In The Hand Vacuum Or; Battery - Stihl SEA 20 Gebrauchsanleitung

17 Troubleshooting

17 Troubleshooting
17.1 Remedying Faults in the Hand Vacuum or Battery
Fault LEDs on the hand
vacuum
Hand vacuum does 1 LED flashing
not start when green.
switched on.
1 LED emits red
light.
3 LEDs flash red.
3 LEDs emit red
light.
4 LEDs flash red.
The hand vacuum 3 LEDs emit red
cuts out during light.
operation.
0458-006-9621-A
Cause
State of charge of the
battery is too low.
The battery is too warm or
too cold.
There is a fault in the hand
vacuum.
The hand vacuum is too
warm.
There is a fault in the

battery.

No electrical contact
between hand vacuum and
battery.
The hand vacuum or
battery is damp.
The hand vacuum is too
warm.
There is an electrical fault. ► Remove battery and reinsert it.
Remedy
► Charge the battery.
► Remove the battery.
► Allow the battery to cool down or warm up.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Switch on the hand vacuum.
► If 3 LEDs continue to flash red: Do not use the hand
vacuum and contact your STIHL dealer for
assistance.
► Remove the battery.
► Wait for the hand vacuum to cool down.
► Remove battery and reinsert it.
► Switch on the hand vacuum.
► If 4 LEDs continue to flash red: Do not use the
battery and contact your STIHL dealer for
assistance.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Allow hand vacuum or battery to dry.
► Remove the battery.
► Wait for the hand vacuum to cool down.
► Switch on the hand vacuum.
English
49