Battery Installation; Battery Connection - Comet CPS 55 ADVANCE BYT Bedienungsanleitung

5. INSTALLATION INFORMATIONS
5.1.

BATTERY INSTALLATION

The battery compartment is located in the rear part
of the solution tank (Photo 9) and to access it is nec-
essary to open the locking door (optional - Photo 9
- A); to allow the opening of the door disconnect the
squeegee lifting cable (Photo 9 - B); to open the door,
lift it up and turn it down, until the brackets stand on
the floor, as shown in (Photo 10).
Place the batteries on the door plain and make the
connection as described in paragraph 6.1.1; after the
battery connection, push them inside the battery
compartment (Photo 11), close the door and recon-
nect the squeegee lifting cable.

5.1.1. BATTERY CONNECTION

Place the general ON/OFF switch ( Photo 4 - H ) in the
OFF position as well as motors switches on the control
panel.
•
Attach the wiring to the batteries, connecting the
terminals exactly and only to the poles marked
with the same symbol (red wiring "+", black wir-
ing "-") according to the wiring diagram shown in
(Photo 12)
•
A short circuit of batteries can cause explosions!
A
B
Photo 9
A) Closing door of the battery compartment (optional)
B) Squeegee lifting cable
Photo 10
A
B
Photo 11
A) Battery compartment with two 12V batteries
B) Closing door of the battery compartment (optional)
Photo 12
Battery connection diagram
32