Draining The Recovery Tank - Comet CPS 55 ADVANCE BYT Bedienungsanleitung

6.8.4. CLEANING OF THE SOLUTION WATER
FILTER
Make sure the solution tank is empty.
Unscrew the filter cap (Photo 24 - A) and remove the
inner wire mesh filtering component.
Clean the filtering component with running water to
remove obstructions and dirt.
After washing, replace the filtering component in its
housing and close the filter screwing tightly the cap
to prevent leakage.
Photo 24
A) Solution water filter
6.9.

DRAINING THE RECOVERY TANK

The dirty water must be drained in accordance with
national regulations.
The user is completely responsible for ensuring com-
pliance with such rules.
When the cleaning solution it is over, before proceed-
ing to fill the tank (see 7.8) it is necessary to always
empty the recovery tank.
In general, the recovery tank can be emptied when-
ever required, and even during intermediate phases
of the work cycle.
The volume of the tank recovery is greater than the
solution tank volume, so you should never experience
a situation of potential danger to the suction motor;
at any rate, there is a safety floating switch (Photo 3 - B
) which stops the suction motor if the level of the dirty
water is excessive.
• If water or foam starts leaking from under the
tanks for any reason, immediately turn off the suction
motor and empty the recovery tank.
To drain the tank:
- Carry the machine to a suitable location to drain
the dirty water and preferably near a toilet or a
sewer drain (comply with the national regulations
for waste water disposal).
- The drainage of the recovery tank can be made
through the drain hose placed at the rear left of
the machine (Picture 25 - A).
- Disconnect the hose from its housing (Photo 26)
and place it at the sewer drain.
- Tighten the rubber sleeve to adjust the drain flow
A
(Photo 26); unscrew the cap of the drain hose and
wait for the complete emptying of the tank.
- After draining, close the hose with the cap and re-
place it in its slot.
After emptying, check the amount of residual dirt in
the recovery tank by lifting the hood and, if necessary,
wash the recovery tank.
A
Photo 25
A) Recovery tank drain hose with adjustable drain flow
Photo 26
Photo 27
38